SEPTIC TANK
Installation Instructions
10 watt PV and Batt Box
1.) If available the "Inlet" inspection pipe is the ideal location for the diffuser/float assembly. DO NOT use "Outlet" inspection pipe for any in tank aeration systems. Other wise locate the the septic tank cover.
2.) Extend diffuser and 6 feet of airline below drill hole, "upstream" of any visible baffles/walls. Seal any gaps between airline entry tube with "non-hardening" plumbers putty to prevent entry of dirt or water into the septic tank.
INSURE locking type manhole covers are securely locked and if applicable, covered with 6 to 12" of topsoil when the job is done.
2.) Connect air tubing to Solar Aerator, white threaded connector and twist to secure.
3.) Inspect pump mount unit and remove external debris weekly.
- Locate septic tank cover and remove.
- Lower diffuser/float assembly into septic tank.
- Point Solar Aerator at sun and attach a standard car battery.
- Securely mount Solar Aerator to a post mounted 2x6 board.
- Connect air line from septic tank to Solar Aerator.
- Utilizing a garden spade, bury air line about 1"- 2" under surface so line is not damaged by lawn mowing and other yard maintenance.
Aerator: A-3 Kit
Aerator air tubing length 20 feet
Aerator box height 6 inches
Aerator box length 10 inches
Total weight 12 lbs.
Air Compressor SCFH= 10
Metal post to mount A-3 Kit (not included).
Solar panel: 10 watt , 18 Volt
Air Compressor: Linear, double diaphragm, AC, 2 lpm
Battery: Deep cycle 12 volt automotive battery and case required. (NOT INCLUDED).
PEC will repair/replace parts at its option.
The seller will not be held responsible for suitability of any product for application or any accidents that may occur while work is carried out by others. We also exclude liability for direct or indirect damage or losses.
Springfield, IL. 62702
tel:888-261-4726 fax: 866-422-0018
email: info@solaraerator.com
TANKAERATOR.COM HOME